What speeds and feeds should the 2" diameter version be run at?
Straight Plunge Router Bits, Non-BG
Status:
Open Jun 14, 2018 - 12:00 AM
1answer
Answer
Jun 14, 2018 - 12:00 AM
You can start at:
75" IPM @ 18,000 RPM
Chip Load Per Tooth: 0.0022"
Ramp Down: 37" IPM
Depth Per Pass: 1/2"
View More Product Details
Straight Plunge Router Bits, Non-BG
Use a two-flute bit where fine finish is paramount. Two flutes balance the bit, eliminating vibration that degrades the cut finish. Two cuts per revolution yield a smooth surface, but feed rate is slightly reduced.Extended life fine micro-grain harder carbide.Superior geometric designAdvanced grindi...
See More
View all Straight Plunge Router Bits, Non-BG Questions & Answers
