Cutting 1/8" brass with Vision Pro VR48 router engraver: recommended RPM, feed rate, and passes
Amana Tool HSS1312 CNC 2D and 3D Carving 0.10 Deg Tapered Angle Flat Bottom 1/8 D x 1-3/32 CH x 1/4 SHK x 2-1/2 Inch Long x 4 Flute ZrN Coated Up-Cut Router Bit
can i use this to cut brass? If so whats the rpm and feed rate? I am cutting thru 1/8" thick brass. is 5 passes ok? I am using vision pro vr 48 router engraver
Status:
Open May 02, 2025 - 09:30 PM
1answer
Answer
May 05, 2025 - 03:47 PM
Dear Hugo,
This can cut brass. The CNC Feed/Speed chart is located on the part page for proper operation under the Downloads tab.
Thanks,
Kevin
View More Product Details
View all Amana Tool HSS1312 CNC 2D and 3D Carving 0.10 Deg Tapered Angle Flat Bottom 1/8 D x 1-3/32 CH x 1/4 SHK x 2-1/2 Inch Long x 4 Flute ZrN Coated Up-Cut Router Bit Questions & Answers
