Answer
Oct 02, 2018 - 12:00 AM
With this bit if the material is 3/16" thick you can run the bit at 55" IPM @18,000 RPM
Chip Load Per Tooth: 0.003"
Depth per pass: 3/16"
Ramp Down: 22.5 IPM
If you use 1/4" material you can use the same parameters
Chip Load Per Tooth: 0.003"
Depth per pass: 3/16"
Ramp Down: 22.5 IPM
If you use 1/4" material you can use the same parameters
